baud rate
美 
英
英汉解释
例句
The baud rate might not be equal to the bit rate, as a symbol might have more than two states.
波特率与比特率可能并不相同，因为一个符号可能包含两个以上的状态。
In microcontroller serial port communication, the system require that the baud rate of dispatcher and sink should keep consistent.
在单片机串行通信中，要求发送和接收的波特率保持一致。
The baud rate of a data communications SYSTEM is the NUMBER of symbols per second transferred.
通讯系统的波特率是每秒传输信息标记（symbols）数。
You should consider either increasing the baud rate used for performing the installation, or performing a Text Mode installation.
您要么通过提高波特率提升安装效率，要么使用文本模式安装。
In the case of the UART, there's not a lot to configure apart from the baud rate and framing details.
对于UART来说，除了波特率和帧细节外没有太多属性要配置。
The baud rate specified is less than or equal to zero, or is greater than the maximum allowable baud rate for the device.
指定的波特率小于或等于零，或者大于设备所允许的最大波特率。
This error indicates that your development machine and target machine do not have the same baud rate.
错误。该错误表示您的开发计算机和目标计算机具有不同的波特率。
This paper introduces a software method for detecting the hardware protocol (baud rate, data bits, etc) of serial data transfer.
介绍了一种用软件侦测串口底层协议（波特率、数据位等）的方法。
CAN protocol provide the baud rate, the cycle of sampling points and the location of the programmable.
CAN通信中，CAN协议提供波特率、位周期内取样点数和位置的编程设置。
In most circumstances, you will want the installer to use the same baud rate as your connection to the EFI console.
大多时候，您会让安装程序使用与连接EFI控制台相同的波特率。
CAN protocol provide the baud rate, the cycle of sampling points and the location of the programmable.
CAN通信中，CAN协议提供波特率、位周期内取样点数和位置的编程设置。
Software component is KEIL C51, through the initial design and implementation of counter baud rate adaptive.
软件部分用的是KEILC51，通过对计数器初值设计实现波特率的自适应。
In most circumstances, you will want the installer to use the same baud rate as your connection to the EFI console.
大多时候，您会让安装程序使用与连接EFI控制台相同的波特率。
Check your current NC machine settings or manuals for the correct baud rate.
检查一下你的现行NC机器设置或手册，调整成正确的波特率。
Baud rate, word length, stop bits, and parity are adjustable from keypad.
波特率、字节长度、停止位以及奇偶位可以在面板上调节。
To get a desired baud rate, write the corresponding value to the Port $7024H and $7025H according to the following Baud Rate equation.
为了得到一个所要求的波特率，需要向$7024H和$7025H端口写入一个合适的值，这个值根据下面的波特率等式得出。
Class using the specified port name, baud rate, parity bit, data bits, and stop bit.
使用指定的端口名称、波特率、奇偶校验位、数据位和停止位初始化。
This is useful for high baud rate terminals that need only a minimal delay.
在需要最小延迟的高波特率的终端上，这种方法很有用。
Class when you want to specify the port name, the baud rate, and the parity bit.
当要指定端口名称、波特率和奇偶校验位时，请使用此构造函数创建。
Therefore limit the baud rate to 76, 800 baud unless required by job specification and observe the following wiring guidelines.
因此限制鲍率为76,800鲍除非被工作规格需要而且观察下列各项配线指导方针。
With this singlechip serial port and baud rate settings, the serial port 1 can only use Timer 1, and the serial port 0 can use Timer 1234.
与此单片机的串口并用设置波特率时，串口1只能用定时器1，而串口0可以用定时器1234。
PT, CT Ratio, Address, Baud rate and other parameters.
变比，通讯地址，波特率等参数
Baud rate of the port.
端口的波特率。
Class using the specified port name, baud rate, and parity bit.
使用指定的端口名称、波特率和奇偶校验位初始化。
The Redirect baud rate specified is being ignored. Use edit option to change the same.
警告：该指定重定向波特率被忽略。使用edit选项来更改。
Baud rate for serial ports.
串口通讯的波特率。
Currently the baud rate of static network in China market is from 100 to 600 while using the spread spectrum technology.
目前中国市场的静态组网的波特率为100~600之间，采用的是扩频方式。
Don't try setting the baud rate on a directory, for example.
例如，不要尝试在目录上设置波特率。
A Method To Automatically Detect Baud Rate Of Serial Communication And Its Software Implementation
串行通信波特率自动检测方法及软件实现
Effect of analog digital conversion and baud rate intercalation to laser atmospheric communication quality
模数转换与波特率设置对大气激光语音通信质量的影响
Define the Baud Rate of Serial Communication Between PC and Single Chip Microcomputer
单片机与PC机串行通信中波特率的确定
Analyzing the Baud Rate Setting Principle in Asynchronous Serial Communication
浅析异步串行通信中波特率的设置原则
DLTB-the control bit of line and baud rate;
DLTB—线路控制位和波特率控制位；
An Method of Baud Rate Self-reacting Used in Serial Communication for Single Chip
单片机串行通信波特率的自适应实现方法
Baud Rate Setting and Its Error Analysis in Serial Communication
串行通讯中的波特率设置和误差分析
A Method to Automatically Detect the Baud Rate of Serial Communication
串行通信中的一种波特率自动检测方法
Analysis on the Baud Rate Parameter Setting of the CAN Bus in Practical Application
CAN总线位速率参数在实际应用中设置的研究分析
The Application of Baud Rate Autoregulation In Single-Chip Communication
波特率自动调整在单片机通讯中的应用
Setting the baud rate for the computer communication
为计算机通信设置波特率
Improved baud rate estimation by wavelet transform
一种改进的基于小波变换的波特率估计算法
